Troubleshooting - Sanyo SFX-30 Instruction Manual

70
Troubleshooting
If moblems occur during operation, check below before taking the unit for service. If the problem cannot be
corrected, contact the dealer from whom the unit was purchased.
Possible Causes/Solutions
AC plug may not be
connected to electrical outlet.
Recording paper may not be set properly.
Rqcording paper may have run out.
Document may be too thin or too thick.
Another document may be jammed inside.
Open operation
panel and remove jammed document. You may have placed
more than 10 sheets.
Page
8
Symptoms
Unit does not operate.
The display indicates CHECK
PAPER ROLL
10
20 Document cannot be insered.
66
Transmission is not possible.
Document may not be inserted enough into the slot.
21
Recording paper may have run out on receiving unit.
Receiving unit may be set for manual reception.
Unit may be set for manual reception. Just lift the handset.
Incoming fax transmission can be received without pressing
ml key.
AC cord may not be connected.
30
Reception is not possible.
(Bell rings).
30
8
10 Recording paper may have run out.
Closed network communication may be on. Check feature
switch No. 26.
Recording paper may have run out.
The recommended recording paper is not used.
Reception is not possible.
63
10
10 Received copy is not dark
enough.
Transmitted original may be light.
21
I
Received copy is blank.
Recording paper may have been inserted upside-down.
Transmitted original may have been upside-down.
—
Phone connection may have been poor. (If problem con-
tinues, contact dealer.)
10
Received copy contains illegible/
distorted characters.
—
10
Red line appears on recording
Recording paper has almost run out.
Install a new recording paper roll.
Press ISTOP/~ to turn off the ERROR LIGHT.
Print an Activity Report.
Check the ERROR CODE.
II
paper.
!4/36
Error lamp lights.
1