Plc - Push Button Setup - D-Link DCS-6045L User Manual

Section 2 - Installation
Alternatively, you may create a secure connection using the PLC Sync Button on the back of the camera.
To create a PLC connection:
Step 1
Make sure the camera is plugged in, then press and hold the PLC button for
three seconds. The green PLC status LED will start blinking.
Step 2
Press the PLC button on your PowerLine adapter within 60 seconds. The PLC
button is usually on the front or side. If you are not sure where the PLC button
is on your adapter, please refer to your adapter User Manual.
The DCS-6045L will automatically create a secure connection to your
PowerLine adapter. While connecting, the green LED will flash and your
camera will reboot.
D-Link DCS-6045L User Manual

PLC - Push Button Setup

PLC Sync Button
PLC Sync Button
20