Miele KM 3054 Operating And Installation Instructions page 35

Problem
The burner does not
ignite when the hob is
being used for the first
time or after a long
period of not being
used.
The burner does not
ignite after several
attempts.
If there is a power cut
during operation
The gas flame goes out
after ignition
The flame pattern has
changed
The flame goes out
during operation
The operation/residual
heat displays for active
cooking zones will flash.
Possible cause
There could be an air lock in the
gas pipe.
The burner is not correctly
assembled.
The gas supply tap is turned off.
The burner is wet or dirty.
The flame slits are blocked and/or
wet
The flames are not touching the
ignition safety device, it is not hot
enough:
- The burner is not
correctly assembled.
- There is dirt on the
ignition safety device
The burner is not correctly
assembled.
The burner head or burner cap
holes are dirty.
The burner is not correctly
assembled.
Power cut.
Power cut.
Problem solving guide
Remedy
You may need to make several
attempts before the burner ignites
successfully.
Turn all the controls clockwise to the
"ß" position and disconnect the
appliance from the electricity supply
for a few seconds.
Assemble the burner correctly.
Turn on the gas supply tap.
Clean and dry the burner.
Clean and dry the flame slits.
Turn all the controls clockwise to the
"ß" position. You can then operate
the appliance as normal when
power is restored.
Assemble the burner correctly.
Remove any soiling.
Assemble the burner correctly.
Remove any soiling.
Assemble the burner correctly.
Turn all the controls clockwise to the
"ß" position. You can then operate
the appliance as normal when
power is restored.
Turn all the controls clockwise to the
"ß" position. You can then operate
the appliance as normal when
power is restored.
35