Installer Quick Setup Guide - LG 20LH1DC1 Installation And Operating Manual

INSTALLER QUICK SETUP GUIDE

Quick Setup Guide for Integrated Master TVs
See table of contents for more information.
HOSPITAL_20 PTC INSTALLER MENU
000 INSTALLER SEQ
UPN 000-000-000-000
PTC V1.00.000 CPU V1.01.00
117 FACT DEFAULT
003 BAND/AFC
028 CH.OVERIDE
Mode Standard
Color Temperature Cool
Screen Format 4:3
Noise Reduction Off
Film Mode Off
11:20 PM
Sep.11, 2006
D E Move OK Select
Mode Standard
Contrast
Color Temperature
Brightness
Screen Format
Sharpness
Noise Reduction
Color
Film Mode
Tint
11:20 PM
Sep.11, 2006
Move OK Select
D E
000
FPGA 20FD
00X
00X
001
G
Menu Back
G
100
79
65
70
0
Menu Back
Antenna
Auto Program
Channel Label
Channel List
Fine Tune
Signal Strength
--:-- --
--.-- ----
Move
D E
Antenna
Wall Jack
Setup Instructions for Making a Master TV
1. Connect TV to signal source, connect power cord and turn TV power on.
2. Enter the TV installer menu.
*Note: If this is not a new setup, set Installer item 117 to 001 and press
Enter to reset TV to default condition.
• Set Tuning Band.
Set Installer menu item 003 BAND/AFC to CATV: 001, Broadcast: 000 etc.
• If necessary, set Installer menu item 028 CH OVERIDE to 001.
In addition, set any other installer items as required of your system.
Exit Installer menu.
3. Access the Master TV menus and set the clonable options on the menus to
the desired configurations. Refer to the Clonable Menu Features Chart for
the TV. (Picture, Sound, Time etc.)
4. Do a Channel Search; run Auto Program. (aka EZ Scan.)
5. Enter the Channel List menu and delete channels per your requirements.
6. Enter the Channel Label menu and assign ICONs to the channels.
*Note: You can add Channel ICONS typically network logos like ABC, NBC,
PBS etc. in this step. Or, in Step 8, add Channel ICONS or custom text
labels for channels which no Icons are available for.
7 . Transfer the TV setup. After all menu options and features are set to your
requirements, enter the installer menu. Press '2', '5', '5', 'MENU' to start the
transfer of the TV's setup to the PTC.
After the transfer is complete, the system will exit the Installer menu.
8. Set any Channel Labels as needed.
a. Enter Installer menu.
b. Press '2' , '5' , '4' , 'MENU' to enter the menu. In this menu edit the
assigned
channel Icons, assign custom text labels for channels and assign labels for
active Aux sources. Press 'Menu' to exit.
9. Enter the Installer menu. Set item 028 Ch Overide to 000 and exit menu.
028 CH.OVERIDE
DIGITAL 19-3
MONO STEREO
G
Auto
OK Select Menu Back
RF Coaxial Wire
(75ohm)
000
ANALOG 2
SAP
WXYZ
MONO
WXYZ
Antenna
Auto Program
Channel Label
Channel List
Fine Tune
Signal Strength
--:-- --
--.-- ----
Menu Back
73