Precautions - Panasonic WV-CP500 Installation Manual

Precautions

This product has no power switch.
Power is supplied from an external 12 V DC/
24 V AC (WV-CP504) or 220 to 240 V AC (WV-
CP500) power-supply device. Refer to service
personnel for how to turn on/off the power.
Use this product for indoor use only.
Do not expose this product to direct sunlight
for hours and do not install the product near a
heater or an air conditioner. Otherwise, it may
cause deformation, discoloration and malfunc-
tion. Keep this product away from water.
To keep on using with stable performance
• Parts of this product may deteriorate and it
may shorten lifetime of this product when
using in locations subject to high tempera-
tures and high humidity. Do not expose
this product to direct heat sources such as
a heater.
• Use this product at temperatures within
–10 °C to +50 °C, and humidity below 90
% (when using this product without turning
the power off).
Do not rub the edges of metal parts with
your hand.
Failure to observe this may cause injury.
Do not attempt to disassemble this prod-
uct.
To prevent electric shock, do not remove
screws or covers.
There are no user-serviceable parts inside. Ask
qualified service personnel for servicing.
Handle this product with care.
Do not abuse this product. Avoid striking,
shaking, etc. The product could be damaged
by improper handling or storage.
Cleaning this product body
Turn the power off when cleaning the product.
Use a dry cloth to clean this product. Do not
use strong abrasive detergent when cleaning
this product. When the dirt is hard to remove,
8
use a mild detergent and wipe gently. Then,
wipe off the remaining detergent with a dry
cloth.
Otherwise, it may cause discoloration. When
using a chemical cloth for cleaning, read the
caution provided with the chemical cloth prod-
uct.
Noise on monitor
This product is equipped with a super sensitive
CCD. Therefore, white dot noise may appear
on the monitor. This phenomenon is not trou-
ble.
Discoloration on the CCD color filter
When continuously shooting a bright light
source such as a spotlight, the color filter of the
CCD may have deteriorated and it may cause
discoloration. Even when changing the fixed
shooting direction after continuously shooting a
spotlight for a certain period, the discoloration
may remain.
Do not aim this product at strong light
sources.
A light source such as a spot light causes a
blooming (light bleeding) or a smear (vertical
lines).
Smear
Blooming
Turn the circuit breaker off which supplies
this product with the power when abnor-
mal conditions are encountered.
Bright subject