Workflow Overview; Connect; Use Presets To Set Up Each Channel - Yamaha TF5 Quick Manual

3. Workflow Overview

Here's a brief overview of how to start mixing using a Presets.
Connect your inputs and outputs

Connect

Connect your inputs and outputs
Connect the instruments and mics.
Connect output devices such as powered speakers.
Input and output settings are ready to go when the
console is shipped, so you can start mixing as soon as
you make your connections (page 12).
Power switch
AC IN connector
Connect the included
power cord.
When your connections are finished, turn on the power.
NOTICE
• Rapidly turning the unit on and off in succession
can cause it to malfunction. After turning the unit
off, wait for at least 6 seconds before turning it
on again.
• This product regularly saves the state of its
workspace so that it can return to the previous
state when the product is turned on. To ensure
that the state is saved properly, wait at least
10 seconds after performing the last operation
before turning the product off.
TF series Quick Guide

Use Presets to Set Up Each Channel

Set up each channel
> Step 1
Select a channel by pressing its [SEL] key
in the Channel Strip section.
The channel's [SEL] key lights, indicating that you
can control the channel using the Display section.
[SEL] key Display section
Library key ( )
> Step 3
Adjust the channel's parameters.
Adjust the input gain, EQ, compressor, and gate
from the OVERVIEW screen and the individual
configuration screens (page 18).
Adjust the input gain on the INPUT screen so that
the loudest sound that is input causes the center
graph to light.
> Repeat steps 1 to 3 and set up each
channel.
NOTE
You can set up channels without using Presets. For details about the available features and parameters, refer to the Reference
Manual.
- 8 -
> Step 2
Press the Library key ( ) to access the
Library and recall a Preset.
Adjusting the input gain