Care And Cleaning; Installation Requirements; Filter Screen; How To Connect Electricity - Haier AHD25 Use & Care Manual

Unplug dehumidifier before cleaning.
Occasionally the dehumidifier will require cleaning.
Use a vacuum cleaner attachment or brush to clean the
front grille. The best way to clean the dehumidifying
coil is by the use of a soft brush when the soil is soft
and wet. (If allowed to dry and harden, it will be
difficult to remove and must be soaked and softened.)

Filter Screen

(on some models)

How to connect electricity

For personal safety, this appliance must
be properly grounded.
The power cord of this appliance is equipped with a
three-prong (grounding) plug which mates with a
standard three-prong (grounding) wall outlet (Fig. 1)
to minimize the possibility of electric shock hazard
from this appliance.
Have the wall outlet and circuit checked by a I-,
electrician to make sure the outlet is properly grounded.
Where a standard two-prong wall outlet is
encountered, it is your personal responsibility and
obligation to have it replaced with a properly
grounded three-prong wall outlet.
Do not allow a lot of water to enter the
electrical/machine compartment through the circular
opening behind the coil. Use a squirt bottle or syringe
so you can control the water.
The filter pulls out from the bottom and down
from the top.
The filter should be cleaned at least every 30 days or
as often as needed. To clean the filter, vacuum it on
the dusty side to remove light dust. Wash the filter,
cleaner side up, under gently flowing water to wash
out accumulated dust and lint. If the filter is very
dirty, use a mild household detergent in wash water.
Let the filter dry thoroughly before replacing it.
DO NOT, UNDER ANY CIRCUMSTANCES,
CUT OR REMOVE THE THIRD (GROUND)
PRONG FROM T~ POWER CORD.
Use of extension cords not recommended
Because of potential safety hazards under certain
conditions, we strongly recommend against the use of
an extension cord. However, if you still elect to use an
extension cord, it is absolutely necessary that it be a
cord having a grounding type plug and outlet and that
the electrical rating of the cord be 15 amperes
(minimum) and 120 volts.
5