Panasonic KX-TD1232 User Manual page 134

Display
The display gives you useful messages about programming. The multiple-line display also shows the
available functions. Follow the message at each step. This is a display sample in the initial
programming mode.
Message Line
Function Line
The message line guides you through programming and lets you con f rm your selection. For example,
when "Jack No? →" is displayed, enter the jack number. The display shows up to 16 characters at a
time. To scroll the display, press → or ←. The function line shows you the function of the Soft button
located below it. When the SHIFT button light beside the display is on, subtitles are available.
Press the SHIFT button to conf rm the available functions.
Jack Number / Extension Number
Certain programming is assigned to each jack number. The jack number is where your telephone
connects to the system. If two telephones share one jack and have their own extension number (eXtra
Device Port [XDP]), the jack number is determined as Jack XX-1 for a proprietary telephone and Jack
XX-2 for a single line telephone. The display may show XX-2, even if an extension has not set XDP.
If you do not know the jack number or extension number, check it as shown below.
If you do not know the jack / extension number
PROGRAM
OR
PAUSE
Press PROGRAM
or PAUSE.
Confirmation
To conf rm your entry after storing data;
• The STORE button light: Lights red.
• Conf rmation Tone:
– One beep: Your entry is accepted.
– Three beeps: Your entry is rejected.
One line type
USR-PGM NO?→
9 9 6
Dial 996.
Multiple line type
(The last two lines)
USR-PGM NO?→
CLR NEXT
Soft buttons
After confirming
PROGRAM
END
OR
PAUSE
Press END. Press PROGRAM
or PAUSE.
Customising Your Phone & System
SHIFT
4-9