Adjusting The Base - Panasonic EY4541 Operating Instructions Manual

3. Insert the blade into the blade
clamp bracket and set the back of
the blade along the roller guide so
that the back of the jigsaw blade
slides along the roller guide.
Roller guide
4. Release the blade Attach/Remove
lever.
• When the blade is secured in place
then lever will return to its original po-
sition.
• Check that the back of blade is setting
in the groove in the roller guide.
WARNING:
If you do not insert the saw blade
deep enough, the saw blade may be
ejected unexpectedly during opera-
tion. This can be extremely danger-
ous.
Removal
1. Lift up the blade Attach/Remove lever.
2. Pull out the blade.

Adjusting the base

1. Use the hex wrench to loosen the
base fixing screw.
2. Move the base along the base ad-
justment hole to set its position. (See
the diagram at right.)
• The base can be adjusted to between
0° and 45° sideways and the for-
ward/back position can also be ad-
justed. If tilting the base sideways,
remove the dust cover first.
• Refer to the bevel index to determine
the angle.
• Rip fence fixing screw should be lo-
cated on the opposite side tool is be-
veled.
3. Use the hex wrench to tighten the
base fixing screw.
- 11 -