Table of Contents
Advertisement
RS-232-C Cables
Configuration
2-6 Installation
I
Configuration
Figure 2-3. HP 27140A Option #540
The peripheral devices must be connected to the panel according to the
directions in their manuals. Generally, one terminal of an RS-232-C cable
will
be connected to the receptacles on the panel, and the opposite ends
will
be connected to their respective receptacles on the device. Cable con-
nectors should be secured in place with screws if they are provided.
For customers fabricating their own cables, Chapter 6 contains tables with
the pin assignment specifications. When making these cables, remember
that the ports are each wired to emulate DCE.
As stated in Chapter 1, "General Information", the MUX
is
fully program-
mable.
To configure port 0 for baud rates other than 9600, and to program ports
1 through 5, please see your
HP-UX System Administrator's Guide. This
information is presented in Chapter 5, "The System Administrator's Tool-
box" for Series 500 Computers.
Advertisement
Table of Contents
