Mobile Software Programming - Siemens A50 Service Manual

Mobile Software Programming

Due to this separation of common mobile software and customer specific initialization, it is
possible to fulfill the demands of the market requiring customization and flexibility.
As a consequence the software programming process in the LSO is divided into two different
steps as followed:
1. Software update to actual version and appropriate language group
2. Programming of CUSTOMER SPECIFIC INITIALIZATION
RS232 Port
FIGURE 2.24 C45 SERIES SOFTWARE PROGRAMMING SETUP
Mobile Software Updating
The software of the mobile, A50/1168, is loaded from a PC directly. Hardware interconnection
between the mobile and the PC is shown in Figure 2.24
Because of the new type of external connector used in X35 (Lumberg type) an additional adaptor
cable between mobile and boot adaptor is required if the "black boot adaptor" is used. Table 2.1
listed all the hardware requirements
If you use the battery dummy, make sure that the power supply voltage is correctly adjusted.
Description
Bootadapter 2000 incl. AC-Adapter, serial
cable and mobile connection cable
IBM Compatible PC – Pentium
TABLE 2.1 EQUIPMENT LIST FOR SOFTWARE PROGRAMMING.
Bootadptor
AC Adaptor
Part No.
L36880-N9241-A200
-
22