Capstan Motor, Conversion Pulley, Timing Belt And Holder - Sony DSR-PD170 Service Manual
Digital camcorder
Hide thumbs
Also See for DSR-PD170:
- Operating instructions manual (176 pages) ,
- Quick start manual (37 pages) ,
- Service manual (19 pages)
Table of Contents
Advertisement
DSR-PD170/PD170P/PD190P
Screw tightening torque tolerance.
0.0098 N.m (0.1 kg.cm)
2-2-10. Capstan Motor, Conversion Pulley, Timing Belt and Holder
Remove the
"2-2-1. Tape Fall Stopper"
"2-2-3. Damper Assembly and Cassette Compartment Assembly"
"2-2-2. Drum Assembly and Drum Base Block Assembly"
"2-2-4. Reel Table (S) / Reel Table (T) Assembly"
"2-2-5. Cassette Base Block Assembly, Gooseneck
Gear Assembly and Relay Gear"
"2-2-6. TG1 Arm Assembly, TG1 Adjustment Plate Assembly, TG7
Arm Block Assembly and TG7 Retainer Spring"
"2-2-7. Brake Slider Assembly and Pinch Slider Assembly"
"2-2-8. Pinch Arm Assembly and Pinch Press Arm"
and "2-2-9. GL Block Assembly"
Removing method Remove in the order of 1,2,3,4
,5,6.
Attaching method: Refer to the following diagram.
After attaching all the parts, refer to the flowchart on page 6-51,
and perform the adjustments from Starting adjustments-1.
Attachment of Timing Belt
1.
Refer to "Removing method", and attach the compression
spring (TG7) and holder to the chassis.
2.
Attach the timing belt to the capstan motor and the conversion
pulley.
Conversion pulley
Timing belt
3.
Attach the conversion pulley to the conversion pulley shaft.
Attach the capstan motor to the chassis.
4.
Secure the capstan motor with the screw.
Conversion pulley
Apply the grease
(1.5mm dia.)
Capstan motor
Conversion pulley shaft
Capstan motor tightening torque
0.0686 N•m (0.7 kg•cm)
Be careful not to touch the
Capstan (
Timing belt
4
5.
After attaching, pull the timing belt lightly, and check that the
movements of the conversion pulley and gear at the back of the
capstan motor are linked.
Hole
Conversion pulley
6-46
Screw
1
Capstan motor
2
part).
3
5
Conversion pulley
6
When the capstan motor is screwed
on with the belt protruding from the
indented part of the
will become fixed.
Capstan motor
Timing belt
Screw
Capstan motor tightening torque
0.0686 N•m (0.7 kg•cm)
1
Screw
Gear
Compression
spring
Not supplied
parts.
Holder
part, the belt
Advertisement
Chapters
Table of Contents
