Miele CS 1028 Operating And Installation Instructions page 46

Gas connection
The gas hob is normally suitable for
connection to either Town Gas, Natural
Gas or Liquid Petroleum Gas.
Depending on your country, the gas
hob is supplied ready for connection to
Town Gas, Natural Gas or Liquid
Petroleum Gas (see label on
appliance).
Depending on country, the appropriate
set of jets for conversion to an
alternative type of gas is included with
the hob.
Depending on the country, the gas
governor (MDG ELITRE with model no.
EL-125) comes with the hob.
If the jets you require are not supplied,
please contact your Miele dealer or the
Service Department.
Conversion to another type of gas is
described under "Conversion to another
type of gas".
LPG Gas Connection
Tubing connection
Please use copper piping or approval
rubber tubing bearing EMSD approval
marking (such as EMSD APPROVAL
GTXXXX and gas pipe for connection
from bottom of unit to gas supply point).
46
Stainless steel braided flexible hose
connection
Please use approval stainless steel
braided flexible tubing bearing EMSD
Approval marking (such as EMSD
APPROVA GTXXXX and gas
accessories and gas cock for
connection from ½ PT connect up to
gas supply point).
Town Gas Connection:
Please use approved stainless steel
braided flexible tubing bearing EMSD
approval marking (such as EMSD
APPROVAL GTXXXX and gas cock for
connection connect from ½ " G
connector to governor, and connect up
to gas supply point.
Warning
Under the Gas Safety (Registration
of Gas Installors and Gas
Contractor) Regulations, only
registered gas installors (registered
to the appropriate class) employed
by registered gas contractors can
personally carry out gas installation
work. "Gas Installation Work"
includes the fabrication, connection,
or replacement of gas pipework,
appliances and fitting.
Please do not use aluminium cover.