Initializing A New Phone System; Cpc Reset ("Ramclear) - Panasonic DBS 576 Technical Manual

Section 400: Programming
Introduction

Initializing a New Phone System

CPC Reset ("RAMCLEAR")
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
576-20-400
After installing a phone system for the first time, the CPC (Central Processing Card)
should be reset to default values before programming the system.
IMPORTANT: This procedure must be performed before you program
the system; otherwise, the system will not work.
The switches, buttons and LEDs in the following
steps are located on the CPC card.
1. Set the CODE rotary switch to 2.
2. Set the RAM HOLD switch to OFF.
3. Press and hold in the MODE button, then
press the RESET button or power-on the
system.
•
Wait for the MJ (Major) and MN (Minor)
LEDs to come on before releasing the
MODE button.
4. Move the RAM HOLD switch to ON.
•
Wait for the system to power itself off,
then back on.
•
All display phones should now show
"Welcome to DBS" on the top line.
5. At any installed display phone, press ON/
OFF. This will bring up Programming Mode,
and display the software version number.
6. Perform Initial Settings for the system,
either manually via Programming Mode
(see next page) or by choosing a set of
preprogrammed initial settings (see pg.
Intro-7).
DBS 576 (USA) issued January 1999
DBS 576
Introduction to
The CPC-576 Card
(front edge, facing out from cabinet)
RUN LED (FPU)
RUN LED (MPU)
MJ LED
MN LED
RESET button
CODE rotary switch
MODE button
RAM HOLD switch
MOH plug-in
•
Programming
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
Page Intro-5