Motorola AP-7131 Product Reference Manual page 197

802.11 b/g/n mode
Power Level
For radio1, specify B, G and
to define whether the 802.11b/g/n radio transmits in the 2.4 Ghz
band exclusively for 802.11b (legacy) clients or transmits in the 2.4
Ghz band for 802.11g/n clients. Selecting b and g enables the
access point to transmit to both b and g clients if legacy clients
(802.11b) partially comprise the network. Select accordingly based
on the MU requirements of the network.
The rates for the access point's 2.4 GHz radio are as follows:
B, G and N - Allows only basic rates (default setting).
B and G - Allows 11b basic rates. Does not allow MCS rates.
G and N - Requires basic rates (either 6, 12, 24 or 1, 2, 5.5, 11, 6,
12, 24).
G Only - Requires one 11g basic rate. Does not allow MCS rates.
B Only - Allows for 11b rates only. Does not allow G or N rates.
N Only - Requires basic MCS rates.
Note: If the mode is B and G, the Channel Width option is not
available, and a Secondary Channel cannot be defined.
For the 5 GHz radio, specify
whether the 802.11a/n radio transmits in the 5 Ghz band
exclusively for 802.11a clients, 802.11n clients or transmits in the
5 Ghz band for both 802.11a/n clients.
A Only - Allows 11a rates.
N Only - Requires basic MCS rates.
A and N - Allows only 11a basic rates (default setting).
Use the drop-down menu to defines the transmit power of the
802.11a/n or 802.11b/g/n antenna(s). The values are expressed in
dBm and mW.
N, B and G, G Only, B only
A and N, A Only or N Only
Network Management 5-59
or N Only
to define