GE 23 Owner's Manual And Installation page 33

PUT THE REFRIGERATOR IN PLACE
4
Move the refrigerator to its final location.
LEVEL THE REFRIGERATOR
5
The refrigerator can be leveled by adjusting
the rollers located near the bottom hinges.
Rollers have three purposes:
• Rollers adjust so the door closes easily when
opened about halfway. (Raise the front about
5/8" [16 mm] from the floor.)
• Rollers adjust so the refrigerator is firmly
positioned on the floor and does not wobble.
• Rollers allow you to move the refrigerator
away from the wall for cleaning.
To adjust the rollers on 23' (33" wide), 25', 26',
27' and 29' models:
• Turn the roller adjusting screws clockwise
to raise the
refrigerator,
counterclockwise
to lower it. Use
a 3/8" hex socket
or wrench, or an
adjustable wrench.
Installation Instructions
Raise
Rollers
Roller adjusting screw
LEVEL THE REFRIGERATOR (cont.)
5
To adjust
the rollers on 23
models:
CustomStyle
™
Turn the front roller
adjusting screws
clockwise to raise
the refrigerator,
counterclockwise
to lower it. Use a 3/8" hex
wrench with extension, or an adjustable wrench.
These models also have rear adjustable
rollers so you can align the refrigerator with
your kitchen cabinets. Use a 3/8" hex wrench
with extension to turn the screws for the rear
clockwise to raise the refrigerator,
counterclockwise to lower it.
LEVEL THE DOORS
6
Adjust the refrigerator door to make the doors
even at the top.
To align:
Using a 7/16" wrench, turn the door adjusting
A
screw to the right to raise the door, to the left
to lower it.
NOTE:
A nylon plug, imbedded in the threads
of the pin, prevents the pin from turning
unless a wrench is used.
After one or two turns of the wrench, open
B
and close the refrigerator door and check
the alignment at the top of the doors.
33
25
'/ '
Roller adjusting screws
Doors should be even at top
Raise
7/16" wrench