Setting Up True Wireless Stereo - HP Roar Plus Features

4

Setting up True Wireless Stereo

If you have two HP Roar Plus Speakers and a Bluetooth device, you can use True Wireless Stereo
(TWS).
1. Power on one of the speakers.
2. Pair the Bluetooth device to this speaker.
3. Power on the second speaker.
4. Press and hold the talk button and the back button on the first speaker to make it the sender.
5. When the first speaker says, "Connect me," set the second speaker as the receiver by pressing
and holding the talk button and the forward button.
6. When the speakers say, "Connected," they are in stereo mode. It takes about seven seconds for
the sender to connect to the receiver.
To end stereo mode, turn off the receiver. The next time you turn on the speakers, they will attempt to
pair with each other.
To disconnect the TWS pairing, turn off the receiver and then press and hold the talk button for six
seconds. All previous pairing information is cleared from the speaker.
4 Chapter 4 Setting up True Wireless Stereo