Wiring - Sanyo CDF-R800 Operating Instructions Manual

Wiring

General
, - - - -
1. Antenna socket
Insert the DIN Antenna plug installed in your vehicle into this socket.
2. Ground wire (Black)
Connect this wire to the vehicle chassis.
3. + 12V Accessory/Ignition wire (Red)
Connect this wire to a terminal that receives power while the ignition switch is ON
or in the Accessory (ACC) position.
Never connect the wire to the car battery directly or the car battery may be
drained.
Note:
receives 12V power while the ignition switch is On, and stands 4A or more of elec-
tric current.
4. + 12V Constant power supply wire (Yellow)
Connect this wire to + 12V power terminal that receives power continuously, and
stands 4A or more of electric current .
Note:
Both of the + 12V Accessory/Ignition wire (Red) and the + 12V Constant power
wire (Yellow) should be connected to their respective terminals to operate
the unit.
5. Power antenna control wire (Blue)
Connect this wire to the control terminal of Power antenna. When not using a
Power antenna, this wire is not used.
Ground wire(Black)
4-Speaker system
Front Left I
Speaker
Front Right I :
Speaker
R e a r Left :
Speaker :
2-Speaker system
Front Left I
Speaker ;
Front Right I
Speaker :
22