GEN
IMPORTANT INFORMATION
INFO
EAS00024
BEARINGS AND OIL SEALS
Install bearings and oil seals so that the manu
facturer's marks or numbers are visible. When
installing oil seals, lubricate the oil seal lips with
a light coat of lithium soap base grease.
Oil bearings liberally when installing, if appro
priate.
1 Oil seal
cC
Do not spin the bearing with compressed air
because this will damage the bearing surfaces.
1 Bearing
EAS00025
CIRCLIPS
Before reassembly, check all circlips carefully
and replace damaged or distorted circlips.
Always replace piston pin clips after one use.
When installing a circlip 1, make sure the
sharp-edged corner 2 is positioned opposite
the thrust 3 that the circlip receives.
4 Shaft
1-3