Filling The Steam Feeder; Important Notes About Steam Cycles - Kenmore 796.91582410 Use & Care Manual

O Pull out the drawer.
Drawer
.....
Lift out the steam feeder.
Steam
Feeder
Tap water
ONLY
Fill the steam feeder with ordinary tap water to the
MAX line or until the water touches the filter screen.
{
Place the steam feeder in the drawer; then push in
the drawer unfit it clicks into place.
iMPORTANT NOTES ABOUT STEAM CYCLES
ADD WATER ]
Before using a steam cycle, the steam feeder must be tiffed with wafer up to the MAX line;
make sure that the drawer is completely closed. Jf the steam feeder runs out of wafer, the ADD
WATER light will bllnk, if the llght blinks, turn the dryer off, refill the feeder, and then restart the
Steam cycle.
When steam is used far the first time, if is possible that the steam feeder may not have enough
water and the ADD WATER light wiff illuminate. Refiff the feeder and restart the cycle.
.Oniy use water. Do not fill the steam feeder with other liquids, rinse agents, or detergents.
•Before moving the dryer, make sure that the steam feeder isempty.
•Do not use distiaJed water; the water level sensor in the steam generator will not work.
•Be careful not to spili water when filling and replacing the steam feeder.
•Wipe up any spilled water around the steam feeder and drawer before starting the dryer.
• During steam operation, the clothes will tumble for only a few seconds, once a minute.
• Do not fili the steam feeder with liquids such as gasoline, dry-cleaning solvents, or other flammable or explosive
substances. They give off vapors that could explode.
• Do not fill the steam feeder with hot water (over 86°F/30°C).
• Do not drink water from the steam feeder.
27