Product Dimensions And Clearances; Tools Required; Advance Planning - GE PSB9100DF Installation Instructions Manual

Design Information
PRODUCT DIMENSIONS AND CLEARANCES
\
1"
21-1/2"
\
\\
\\
\
\
\\
\
E
L_J
-,_ 13" _
1-4/5"
26-3/4" _"
I oo oo o_ moo ]
O0 O0 0 0 0 O0
NOTE: Appearance may vary slightly by model.
18-5/8"
TOOLS REQUIRED
• #2, Phillips screwdriver
• Hondheld drill
• High-speed drill bit, 1/8" diameter
,, 3/8", slot-head screwdriver
PARTS SUPPLIED
• 6 Brass screws (3 required, 3 extra)
• 5 Color-matched screws (4 required, 1 extra)
• Bottom trim
ADVANCE PLANNING
• These ovens may be installed directly into
a 27"-wide oven cabinet.
• The front surface of the oven will be nearly flush
with surrounding cabinetry doors.
• This oven con be installed over any GE single electric
built-in oven or a warming drawer or both.
IMPORTANT: This oven is not approved for use above
another built-in SpeedCook oven, o side-by-side
installation or below o countertop.
• For personal safety, this oven cannot be installed
in o cabinet arrangement such us on island or
peninsula.
• The oven must be installed at least 36-3/4" above
the floor.
• Allow for clearance to adjacent corners, walls,
drawers, etc.
• Cabinets installed adjacent to wall ovens must hove
on adhesion spec of at least 194°F temperature
rating.
The oven must be securely installed in a cabinet that
is firmly attached to the house structure. Weight on
the oven door could cause the oven to tip and result
in injury. Never allow anyone to climb, sit, stand or
hang on the oven door.
4