Diffuser Purpose; Diffuser Installation And Removal - Sony 6116.12 RX100 III Instruction Manual

Diffuser Purpose

When using the built-in camera flash and shooting close-up photographs,
the lens port on the housing can block a portion of the light from the
built-in camera flash. This can result in a shadow in a lower corner of the
picture frame. The Diffuser will help eliminate the shadow. In addition,
you can zoom in if necessary.

Diffuser Installation and Removal

The included Diffuser should only be used when shooting with the
built-in camera flash. Always remove the Deflector before using ONLY
the built-in camera flash with a Diffuser.
To install the diffuser, push the "Cut-out Section" into the Port Groove
until it stops as shown. To remove, grab the top of the Diffuser and pull
away from the port.
Note the Small Hole. To avoid losing the diffuser, you can attach a
fishing line or string to this hole.
Cut-out
Section
Small hole
Diffuser
Diffuser properly
installed in Port Groove
15