Table of Contents
Advertisement
UNPACKING
The package contains:
- Handset
- Base Station
- 3 AAA batteries
(Ni-MH 1.2V 600mAh)
- Mains Adapter (9VAC 1000mA)
IMPORTANT!
Only use with the supplied power adapter.
CONNECTION
1. Connect the mains to adapter to the POWER socket on the base
station and an electrical wall socket.
2. Carefully remove the handset battery cover. Insert the batteries
into the handset ensuring correct battery polarity is observed,
replace the battery cover.
3. Place the handset in the base station, with the keypad facing
outwards. Once the handset is correctly positioned in the base
station, a beep will be heard.
4. Leave the handset to charge initially for 12 hours before use.
5. Connect the phone cable to the RJ-11 port on the back of the
base station.
6. Plug the other end of phone cable into the telephone network
wall socket.
7. Connect the Ethernet cable to the LAN port on the back of the
base station.
8. Plug the other end of Ethernet cable into a spare port in your
Router/Gateway.
IMPORTANT!
Under power failure conditions the DPH-C160S will not operate. Please ensure that a
separate telephone not dependant on local power is available for emergency use. The
earpiece of the handset may attract small objects such as staples and pins, care should
be taken when placing the handset near these items. Do not place the base station close
to other electrical equipment such as TVs, microwaves, computer screens, fans, etc. This
will minimise the risk of interference. Do not place the base station in areas where it will
be exposed to direct sunlight or other major heat sources.
5
Installation
- Ethernet Cable
- Phone Cable
- Belt Clip
- CDROM (Quick Setup Utility)
www.dlink.com.au
Advertisement
Table of Contents
