Sony SRS-X99 Operating Instructions Manual page 9

 UPDATE button
Indicates the status of the unit's software
update.
 LINK indicator
Indicates the status of the network
connection of the unit.
 VOL (volume) –/+ buttons
Tap to adjust the volume.
The / (on/standby) indicator and
reaction indicator flash according to the
volume adjustment when tapped.
 / (on/standby) button/indicator
Tap to turn the power of the unit on and
off.
 Wi-Fi antenna
Set upright during Wi-Fi connection as
below.
 Swing the left side of the antenna
outwards.
 Pull out the antenna.
 Rotate the antenna 90 degrees
clockwise.
 Bring up the antenna.
 N-Mark
If your smartphone is NFC-compatible,
touch the smartphone on the N-Mark.
The unit will turn on automatically and
registering (pairing) and BLUETOOTH
connection can be made.
 AC IN terminal
Connect the AC power cord (supplied).
 AUDIO IN jack
Connect to the headphone jack of a
portable audio device, etc., using a audio
cable (not supplied).
 WPS button
Press and hold when connecting to a Wi-
Fi network.
Beeps will be heard by pressing and
holding the WPS button for 2 seconds,
which indicates that the unit is ready to
connect to a wireless router.
If your wireless router has a WPS button,
you can use this button to connect to the
network.
 LAN port
Use a LAN cable (not supplied) to
connect the PC or the wireless router.
 USB B port (
B)
Connect a PC using a USB cable (not
supplied).
When connecting a high-resolution
supported Walkman®, use the optional
High-Resolution Audio USB Adaptor WM-
PORT Cable.
 USB A port (
A)
Connect a USB flash drive directly. When
connecting to an iPhone/iPad/iPod or
Walkman®, use the cable supplied with
the device.
 Remote sensor/Reaction indicator
When the unit receives signals from the
supplied remote control, the reaction
indicator (remote sensor) flashes.
Also, the indicator flashes according to
the volume adjustment of the unit.
9 US