Epson DM-D500 Technical Reference Manual page 49

DIP switch 2
DSW2
Function
No.
2-1 Y Connection Setting
2-2 Self-test Execution (*1)
2-3 20 column 2 line Mode Set-
ting (*2)
2-4 Default Device Selection
Setting (*3)
2-5 Address 0 (*4)
2-6 Address 1 (*4)
2-7 Address 2 (*4)
2-8 Reserved for system (*5)
(*1) Sets whether or not to run the self-test when power is turned on. For details on the self-test, see "Self-test".
(*2) In OPOS and APD4, use the DIP switch in default setting: "256x64 mode". Selecting "20 column 2 line mode" allows the display to be used as
a replacement of DM-D105, 106, 205, or 206. In this mode, graphics display and functions unique to DM-D500 are unavailable. Selecting
"256x64" mode makes graphics display and functions unique to DM-D500 become available.
(*3) In OPOS and APD4, use the DIP switch in default setting: "Display". When "Printer" is selected, data is output to the TM printer but not dis-
played on the display. When "Display" is selected, data is displayed on the display but not output from the TM printer. The device selection can
be changed by using the ESC/POS command.
(*4) In OPOS and APD4, use the DIP switch in default setting.
(*5) Do not change the OFF setting.
Changing the DIP switch settings
When removing the DIP switch cover, be sure DM-D500 is turned off. Removing the cover with the power
turned on may cause short circuit, which may damage the product.
1
Turn off DM-D500.
2
Remove the DIP switch cover.
DIP switch cover
ON
Enabled Disabled
Yes No
20 column x 2 line 256 x 64 mode
mode
Printer Display
Three bits: address bit 0 to 2 are
used for display number (1 to 7).
(However, there is no display number
when all the bits are OFF)
- Fixed to OFF
DSW1
Default
OFF
setting
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
DSW2
Chapter 2 Setup
2
49