Pioneer CDX-PD6 Service Manual page 57

10. Remove the screw, pressure spring and collar. Lift
up the Carriage mechanism assy to remove it.
* Screw tightening torque: 2.6kgfcm
- How to remove the Pickup unit
1. Remove the pulling spring, torsion spring and E-
shaped ring. Then remove the Clamper arm.
* The spring (A) will be removed with the Clamper
arm.
2. Slide the Clamp UP lever (B) to remove it.
3. Loosen the 2 screws. Remove the feed-screw cover
by sliding it.
4. Remove the feed-screw pressure spring (D).
5. Loosen the 2 screws. Remove the feed-screw holder
(E).
6. Remove the belt.
Carriage
motor
Pickup
unit
Belt
Feed screw
Pressure spring
Pulling spring
Torsion spring
7. Remove the Pickup unit together with the feed screw.
* Be careful not to lose the shaft holders at the both
ends of the feed screw.
* Be careful not to damage the 2 flexible PCBs(for the
Pickup and motor) when separating them. The flexi-
ble PCBs have been stuck each other with double-
sided adhesive tape.
White
Black
Fig. 10
CDX-PD6
Screw
Collar
Carriage mecha-
nism Assy
Fig. 8
E-shaped ring
Clamper arm
Fig. 9
57