Section 1. Housing Separation - Bosch EX10 Installation Instructions Manual

1. HOUSING SEPARATION
Separating the two halves of the camera
housing allows access to the Voltage Regulator
Board (VRB) and camera. This is only used as a
reference since all the settings are preset at the
factory.
Step 1.1 -
Step 1.2 -
Remove the two housing screws
located on each side of the EX10
camera housing.
Refer to Figure 1-1 on page 5.
Slide both sections of the housing
apart without damaging the camera
connecting leads. Disconnect the
camera connector to completely
separate the two halves of the
housing. Ensure that the "O" ring
gasket does not pull out of its
groove during separation. If the
gasket does separate, it is important
that it is not lost. Re-insertion the
gasket into the groove.
Refer to Figure 1-2 on page 6.
- 4 -