Standby Mode Function; Setting The Hd Visual Communication System To Standby Mode - Sony IPELA PCS-XG100 Operating Instructions Manual

• When you turn on the power of the Communication System for the first time after
installation, the setup wizard will appear after the self-diagnosis is completed. Set up
your system following the wizard.
For setups using the wizard, see "Setting Up the System Immediately after
the Installation – Initial Setup Wizard" on page 46.
• Used with an optional device especially designed for use with this system, such as the
ISDN Unit, for the first time, the Communication System may automatically upgrade
the software of the connected device. Upgrade the software according to the message
displayed on the monitor screen. Be sure not to turn off the Communication System
or disconnect the cable during upgrading. Otherwise, it may cause a malfunction of
the system. System malfunction may also occur when a system power-off has been
caused by an accidental problem such as a power interruption during upgrading. If
connection of the Camera Unit, ISDN Unit, etc. to the Communication System is not
re-established even after the system power is recovered, consult a Sony dealer.
• You can check the versions of the Communication System, optional dedicated
equipment connected and the application software installed using the Machine Status
menu.
For details on the Machine Status menu, see page 98.

Standby Mode Function

To save power, the Communication System will enter standby mode if you do
not operate it for a specified period of time. When the Communication System
is in standby mode, the
You can turn on the Communication System with any button on the Remote
Commander if the System is in standby mode.
Once the Communication System receives a call, the standby mode is
automatically released.

Setting the HD Visual Communication System to Standby Mode

1
Display the Home menu on the monitor screen, then press the
on the Remote Commander.
The message "Power off?" appears on the monitor screen.
2
Press the V, v, B or b button on the Remote Commander to select OK, then
press the ENTER button.
Alternatively, you can press the
The Communication System enters standby mode, and the
switch indicator on the Communication System lights in orange.
To cancel setting the system to standby
Select "Cancel" with the V, v, B or b button on the Remote Commander, then
press the ENTER button in step 2 above.
1 (power) switch indicator lights in orange.
/ button on the Remote Commander.
@ 1
@ / 1
(power)
1
Turning the System On/Off
button
43