Outgoing Call No Answer Time; Pause Time For - Panasonic KX-TVA50 Programming Manual

2.5.4 Parameters
Note
•
Make sure that the duration of Call Transfer No Answer Time is longer than the duration of Call
Forwarding No Answer Time at the PBX. Otherwise, the PBX may forward the call immediately to the
extension's Intercept Routing destination according to PBX programming, rather than return the call to
the VPS.
Default
20 s
Value Range
10 s–60 s

Outgoing Call No Answer Time

Specifies the length of time that the VPS waits before concluding that there is no answer at the outside number
called.
Default
30 s
Value Range
10 s–90 s

Pause Time for ","

Specifies the pause time for "," used in call sequences.
Default
1000 ms
Value Range
100 ms–9900 ms, units 100 ms
Pause Time for ";"
Specifies the pause time for ";" used in call sequences.
Default
3000 ms
Value Range
100 ms–9900 ms, units 100 ms
Outside Call Setup Sequence
Specifies the sequence of codes used by the VPS when calling a trunk (CO line). You can set a maximum of
16 digits. The default value is "T". "T" indicates that the VPS will dial the telephone number only after detecting
a dial tone.
Example:
9, = (9) – 1 s wait – dial telephone number. "9" is the trunk (CO line) access number.
162 Programming Manual Document Version 3.0 2010/06