Silvercrest SKD 1000 A2 User Manual And Service Information page 15

Cassette Digitizer SilverCrest SKD 1000 A2
1. Slide the black release button (5) in the direction indicated by the arrow to
release the cassette compartment cover, and then raise the cover.
2. Insert your fingernail into the recess above the cover of the battery
compartment (13) and open the cover. Remove the cover and put it to one
side.
3. Insert the supplied AA batteries into the unit with the correct polarity (+ and -).
Push the first battery as far as you can to the left so that it is no longer visible,
and then insert the second battery (see the diagram to the left of the battery
compartment).
4. Replace the cover on the battery compartment. First position its lower edge on
the two lugs at the bottom left and right of the battery compartment, and then
carefully press down the top edge of the cover with your finger until it clicks into
place.
If the volume level drops, or if the device stops operating or the
playback becomes distorted, replace the batteries with new batteries
of the same type. The device does not provide an indication that the
batteries are weak.
English 13