Installing Solar Power Conditioner Display - Sharp JH-3500U Installation & Operator's Manual

Installing Solar Power Conditioner Display

Follow all WARNING and CAUTION on Location of Installation Instructions (page 6).
WARNING
• Do not install the display outdoors, as it may be damaged leading to smoking or fire.
CAUTION
• Signal cable of the display should not be cut or fastened, as it may cause malfunction.
• Use the included signal cable to connect the solar power conditioner and the display.
• Do not pull the signal cable at the connector, as it may break the wire.
1. Insert the larger 4-pin connector of the signal cable to the display jack in the solar power
conditioner (listen for clicking sound that ensures it is locked in place).
2. Connect the ground cable to the ground terminal in the solar power conditioner,
and tighten the installed screw with Phillips screw driver.
3. Insert the flat-head screwdriver into the slits on the bottom of the display, and twist the screw
driver in the direction of the diagram to open the front cover(See below for detail).
4. When the front cover is opened (small clicking sound), remove the front cover.
5. Insert the smaller connector of the signal cable from the backside of the display.
19