JVC DR-MV1S Instructions Manual page 90

TROUBLESHOOTING
90
EN
Playback (VCR Deck)
The VCR deck can not be operated.
● The VCR deck is not selected.
]Press VCR/DVD repeatedly so that the VCR lamp lights up on
the unit.
The tape will not rewind or fast-forward.
● The tape is already fully rewound or fast-forwarded.
]Check the cassette.
The playback picture does not appear while the tape is running.
● The TV is not set to the AV mode.
]Set the TV to the AV mode.
Noise appears during visual search.
● This is normal.
Noise appears during normal playback.
● The automatic tracking mode is engaged.
]Try manual tracking. (
The playback picture is blurred or interrupted while TV
broadcasts are clear or "USE CLEANING CASSETTE" message
appears on the screen.
● The video heads may be dirty.
]Use a dry cleaning cassette ECL-3F, or consult your JVC dealer.
Breaks are noticeable in Hi-Fi soundtrack.
● The automatic tracking mode is engaged.
]Try manual tracking. (
Recording (DVD Deck)
The desired programme cannot be recorded.
● The channel position does not correspond to that in the
receiving area.
]Set the correct channel position for the receiving broadcast.
( pg. 83)
Recording cannot be made.
● No disc or a disc not being compatible with the unit is loaded.
]Load a recordable disc on the unit. (
● The disc loaded is not formatted.
]Format the disc. ( pg. 86)
● A finalised DVD-R disc is loaded.
]Recording cannot be made on finalised discs. Load a recordable
disc on the unit.
● The disc is full or does not have enough space for the
programme to be recorded.
]Clear unnecessary programmes on the disc or load a blank disc.
( pg. 59)
pg. 51)
pg. 51)
pg. 6)
Recording (VCR Deck)
During recording, the tape does not run. The VCR recording lamp
lights up on the front display panel.
● The unit is in the Record Pause mode.
Press 4 to resume recording.
Recording cannot be made.
● There is no cassette loaded, or the cassette loaded has had its
record safety tab removed.
]Insert a cassette, or using adhesive tape, cover the hole where
the tab was removed.
TV broadcasts cannot be recorded.
● "L-1", "L-2" or "F-1" has been selected as the input mode.
]Select the desired channel.
Camcorder recording is not possible.
● The camcorder has not been properly connected.
]Confirm that the camcorder is properly connected.
● The input mode is not correct.
]Set the input mode to "F-1".
The tape is automatically rewound, then the unit is shut off.
● The end of the tape was reached during recording.
]The programme may not have been recorded in its entirety. Next
time make sure you have enough time on the tape to record the
entire programme.