Setting The Timer - Haier HCW3460AES User Manual

THE OVEN CLOCK
IMPORTANT: Following initial installation and power failures, the time-of-day
(12:00 a.m.) will blink to alert you to set the correct time of day. The oven will not
operate until the time-of-day has been set.
SETTING THE TIME OF DAY
Push in on the Time/Temp knob to toggle between the time-of-day and the timer,
and to view the set times.
1. Turn the Oven Mode knob to the OFF position.
2. Turn the -/+ knob to the left or right, the time display starts to flash.
NOTE: Hours and minutes are set separately.
3. Turn the knob again, until just the hour digits start to flash.
4. Adjust the flashing hour numerals by turning the -/+ knob to the left or right.
5. Push in on the -/+ knob once to set the hours and the minute numerals will begin
to flash.
6. Adjust the flashing minute numerals by turning the -/+ knob to the left or right.
After a few seconds both the hour and minute numerals will start flashing.
7. Wait another 10 seconds until the new time of day is steady. The time is now set.

SETTING THE TIMER

NOTES:
•
The display will show the time-of-day (default), until you push the knob to select
the timer .
•
The timer can be set for an amount of time from 0 to 240 minutes.
•
The default time is 30 minutes.
•
The oven timer may be used to time other activities even when the oven is
turned off.
To Adjust the Timer:
1. Push in on the knob to select the timer.
2. Turn the knob right or left to select the time.
3. When the time expires, the
repeated every 3 seconds.
4. Push in on the knob to stop the timer alarm.
Convect
Roast
flashes and the timer sounds with two short beeps
- +
11