Rider Information Display - Polaris 2009 Sportsman XP 850 Service Manual

Rider Information Display

The rider information display is located in the instrument
cluster. All segments will light up for 1 second at start-up.
NOTE: If the instrument cluster fails to illuminate, a
battery over-voltage may have occurred and the
instrument cluster may have shut off to protect the
electronic speedometer.
1. RPM / Vehicle Speed Display - LCD display of either
engine RPM or vehicle speed in MPH or km/h.
2. Information Area - Service / Odometer / Engine Hours
/ Tripmeter Display - LCD display of the service hour
interval, total vehicle miles or km., total engine hours, and
two separate trip odometers.
3. MPH / km/h Display - MPH is displayed when the
instrument cluster is in the "Standard" mode. Km/h is
displayed when the instrument cluster is in the "Metric"
mode.
4. High Beam Indicator LED and LCD icon illuminate
whenever the LH control headlamp switch is in the high
beam position.
5. Fuel Level Indicator - LCD bar graph indicating current
fuel level. All segments will flash when the last segment is
cleared indicating a low fuel warning.
6. Clock - Displays current time in either 12-hour or 24-hour
formats.
7. Engine Temperature Indicator - LED and LCD icons
illuminate when the ECU determines the engine is
overheating. The indicators will initially flash to indicate
the engine is overheating. The indicators will stay lit and
not flash if a severe overheating condition exists.
8. Service Interval Indicator - Preset at the factory at 50
hours and adjustable by the user, the icon will illuminate at
engine start-up for 10 seconds when the engine hours meet
the hour threshold indicating when maintenance should be
performed.
9. Select Button - Press and release to toggle through the
information area fields. The fields are: Odometer, tripmeter
1 / tripmeter 2, engine hours, and service interval. The
information area will also display any current Diagnostic
Trouble Codes (DTC) if applicable.
NOTE: Select button locked out when vehicle speed
is above 15 MPH.
10. Battery Voltage Indicator - LCD icon is displayed when
the battery voltage is either too low (less than 10V) or too
high (greater than 16V) as determined by the ECU.
11. Check Engine MIL - Illuminated when the ECU has
detected a Diagnostic Trouble Code in the engine
management system. Icon will flash when DTC display
mode is active.
12. Mode Button - Press and release to toggle between engine
RPM or vehicle speed displays. The mode button is also
used to change units, reset the tripmeters, enter clock set
mode, enter service interval update, toggle through DTCs,
and display the clock with key out of ignition.
NOTE: Mode button locked out when vehicle speed
is above 15 MPH.
13. AWD Indicator - Illuminated when the RH control switch
is in either AWD or ADC AWD mode.
14. Neutral Gear Indicator - LED illuminated when gear
selector is in the neutral (N) position.
15. Gear Position Indicator - Displays gear selector position.
H = High
L = Low
N = Neutral
R = Reverse
P = Park
-- = Error (shifter stuck between gears)
16. Power Steering System MIL - LED illuminates when a
fault has occurred with the power steering system. The LED
will illuminate when DTC display mode is active.
17. Turn Signal / Hazard Lamp Indicator - (International
Models Only) LED illuminates whenever the LH, RH or
hazard lamps are activated.
ELECTRICAL
12
12.5