Craftsman 315.115940 Operator's Manual page 10

WARNING:
Battery products are always in operat-
ing condition. Therefore, the switch should always
be in the OFF position when not in use or carrying at
your side.
INSTALLING CONTROLLER BATTERIES
See Figure 7.
Always turn the switches for the truck and the controller
to the OFF position when installing the battery in the
controller.
 Remove the battery cover from the controller.
 Install a 9 V battery according to polarity indicators
(+ or -) inside the battery compartment.
 Replace and secure the battery cover.
NOTE: If the truck becomes difficult to control, the battery
may need to be replaced (or recharged, if rechargeable).
ON/OFF SWITCHES
See Figures 8 - 9.
Both the truck and controller have an ON/OFF switch. The
controller switch is located on its handle. The truck switch
is located on the underside of the truck.
When the controller is turned ON, the red LED glows.
9 V
BATTERY
OPERATION
 Always turn the controller's ON/OFF switch to the ON
 Next, turn the truck's ON/OFF switch to the ON
 Use the throttle trigger and steering wheel to get where
 When you're done cruising around, always turn the
CONTROLLER
BATTERY COVER
CONTROLLER
Fig. 7
10
position first.
NOTE: For best performance and control of the truck,
fully extend the controller antenna. The antenna does
not have to be pointed at the truck.
position.
you want to go.
truck's switch to the OFF position before you turn the
controller's switch to the OFF position.
CONTROLLER
ON/OFF SWITCH
FRONT END OF TRUCk
OFF
POSITION
Fig. 8
TRUCk ON/OFF
SWITCH
(SHOWN IN ON
POSITION)
Fig. 9