Installing The Cover - Asus 1U Rackmount Chassis Kit R10-A2P4 User Manual

2.2.2 Installing the cover

1. Position the cover on top of the chassis with the thumbscrews on the
rear, and leaving a gap of about half an inch from the front panel.
2. Make sure that the side markings on the cover (two on each side) are
aligned to the grooves on the chassis.
3. Slide the cover toward the front until it snaps in place.
4. Tighten the thumbscrews on the rear to secure the cover.
2-4
Thumbscrews
Chapter 2: Hardware setup
Side markings
Grooves