Rear Panel Of The Control Surface (Cs-R10) - Yamaha RIVAGE PM10 Operation Manual

Part Names & Functions  Rear panel of the control surface (CS-R10)

Rear panel of the control surface (CS-R10)

1 1
2 3
(
7
@
8
)
9
! #
%
$ ^ & *
1 LAMP jacks
These four 4-pin female XLR output connectors are used to supply power to Yamaha LA1L
gooseneck lamps supplied with the unit.
2 MIDI OUT/IN jacks
These connectors are used to transmit and receive MIDI messages to/from external MIDI
devices.
3 GPI connector
This is a D-sub 25-pin female connector that allows communication (8-in, 8-out) with a GPI-
equipped external device.
4 [FAN] switch
Sets the internal cooling fan to operate at either HIGH or LOW speed.
NOTE
This switch is set to LOW when the unit is initially shipped from the factory. As long as the unit is
operated within the specified ambient temperature range either the LOW or HIGH setting can be
used. The HIGH setting is recommended if the ambient temperature is high, if the unit is in direct
sunlight even if the ambient temperature is within the specified operating range, and in any
situation in which fan noise is not a problem.
5
VIDEO OUT connector
Connect your external display monitor to this DVI-D connector.
1
1
4 5 6
(
(
B
A
6 [RESET] switch
Resets the control surface.
Only the controls (screens, indicators, and control keys and knobs) on the control surface will
restart without interrupting audio. Use this switch in case the control surface becomes non-
responsive to your operations.
7 OMNI IN jacks
These are balanced XLR-3-31 female input jacks for inputting analog audio signals from line
level devices or microphones. They feature SILK digital processing.
Male XLR plug
8 OMNI OUT jacks
These are balanced XLR-3-32 male output jacks that transmit analog audio signals.
Female XLR plug
9 AES/EBU jacks
Both input and output jacks feature built-in sampling rate converters.
IN
These are balanced XLR-3-31 female input jacks that accept digital audio signals in AES/EBU
format.
OUT
These are balanced XLR-3-32 male output jacks for outputting digital audio signals in the AES/
EBU format.
) MY card slots
Install optional Mini-YGDAI I/O cards here to expand I/O ports.
! USB ports
Use these ports to connect a USB storage device such as a flash drive, USB mouse, or USB
keyboard.
@ WORD CLOCK OUT connector
This BNC connector is used to transmit word clock signal to an external device.
16
CONTENTS FUNCTION MAP
1 (ground)
3 (Cold)
2 (Hot)
2 (hot)
3 (Cold)
1 (ground)
RIVAGE PM10 Operation Manual
FAQ