Patching The Output Ports - Yamaha RIVAGE PM10 Operation Manual

Patching  Patching the output ports

Patching the output ports

1.
Press the PATCH button on the menu bar to access the PATCH screen.
2.
Press the OUTPUT tab to access the OUTPUT patch window.
The window contains the following items.
5
1 2
1 Channel list (Output channels)
Indicates the output channel numbers as patching destinations.
2 Channel display
Indicates the channels that will be assigned to the output port.
3 Grid
This grid lets you patch output ports (horizontal lines) to output channels (vertical columns).
Currently-patched grids are indicated by white squares. Press or click a desired grid to set or
disable the patch.
4
3 6
71
4 OUTPUT COMPONENT/SLOT/CH
This section indicates the type of the output component, slot number, and channel number for
the output port.
The abbreviations displayed in this section have the following meaning.
• M1–M2...........................I/O rack 1–2
• CONSOLE .....................Control surface
• DSP .................................DSP engine
5 Continuous patch button
Press the continuous patch button, and then rotate the select knob to in the upper right to
patch the intersecting channels continuously.
If you press the continuous patch button, the
Press the button again to confirm the selected continuous patches. Press the
to revert the continuous patches to the previous state.
6 CLEAR ALL button
Press this button to clear all selections.
3.
Use the knob in the upper right to display the desired output ports.
4.
Use the knob in the lower-left corner to display the output channels.
5.
Press the desired grid cell to patch a desired channel.
CONTENTS FUNCTION MAP
button and the button will appear.
RIVAGE PM10 Operation Manual
FAQ
button