Charging Method - Hitachi FDS10DVA Instruction Manual

CHARGING METHOD

Battery
Nameplate
Fig. 9
2. Insert the plug of battery charger into the receptacle.
WARNING:
3. Charging
When the plug of battery charger has been inserted into the receptacle,
charging will commence and the pilot lamp will light on.
NOTE: If the pilot lamp does not light, pull out the plug from the receptacle and
check if the battery is properly mounted.
In approx. one hour, when the battery is fully charged, the pilot lamp will go
out.
NOTE: The battery charging time becomes longer when a temperature is low or
the voltage of the power source is too low.
When the pilot lamp does not go off even if more than four hour has
passed after start of the charging, stop the charging and contact your
HITACHI AUTHORIZED SERVICE CENTER.
14
NOTE:
Before plugging into the receptacle, make sure
the following points.
1. Insert the battery to the battey charger.
Pilot Lamp
Do not use the electrical cord if damaged.
Have it repaired immediately.
The power source voltage is stated on the
nameplate.
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indi-
cated on the nameplate.
If charged at voltage higher than indicated
on the nameplate, the charger will burn up.
Insert the battery into the battery charger as
shown in Fig. 9
Make sure it contacts the bottom of the
battery charger.