Table of Contents
Advertisement
End of cutting operation
4. Precaution after finishing the planing operation
When the planer is suspended with one hand after
finishing the planing operation, ensure that the
cutting blades (base) of the planer do not contact
or come too near your body. Failure to do so could
result in serious injury.
BLADE ASSEMBLY AND DISASSEMBLY AND
ADJUSTMENT OF BLADE HEIGHT
1. Blade disassembly:
(1) As shown in Fig. 4, use the accessory box wrench
to loosen the three bolts used to retain the blade,
and remove the blade holder.
Blade holder
(2) As shown in Fig. 5, slide the blade in the direction
indicated by the arrow to disassemble the blade.
CAUTION
Be careful not to injure your hands.
3
Fig. 3
Box wrench
Bolt
Fig. 4
Fig. 5
2. Blade assembly:
CAUTION
Prior to assembly, thoroughly wipe off all swarf
accumulated on the blade.
(1) Insert a turned portion of the set plate (A) attached
to the blade into a groove on the flat portion
of the cutter block. (Fig. 6, 7)
Set the blade so that both sides of the blade
protrude from the width of the cutter block by
about 1 mm. (Fig. 8)
Set plate (A)
Turned
portion
Groove
1 mm
Blade
Flat portion of
the cutter block
Set plate (A)
Fig. 6
Blade
Fig. 7
1 mm
Cutter block
Fig. 8
Advertisement
Table of Contents
