Panasonic AW-HE100E Operating Instructions Manual page 54

Setting the menu items
Genlock setting menu
The same settings established on the genlock setting menu
are common to all the shooting modes (halogen light mode,
fluorescent light mode, daylight mode and user mode).
(When a setting in one mode is changed, the same setting
is established in the other modes.)
 G/L Set 
H Phase
1--------
SC Coarse
2--------
SC Fine
3--------
Return
4------
1 Horizontal phase adjustment
[H Phase: –206 to +49]
(Factory setting: ±0)
Using this item, the horizontal phase during genlock can
be adjusted.
2 Colour phase coarse adjustment
[SC Coarse: 0deg, 45deg, 90deg, 135deg,
180deg, 225deg, 270deg, 315deg]
(Factory setting: 90deg)
Using this item, the colour phase during genlock can be
adjusted coarsely. This setting takes effect only when
VBS or Y/C signals are output as the video signals.
3 Colour phase fine adjustment
[SC Fine: –127 to +127]
(Factory setting: ±0)
Using this item, the colour phase during genlock can be
adjusted finely. This setting takes effect only when VBS or
Y/C signals are output as the video signals.
4 Return to the previous menu (menu for
selecting the shooting mode) [Return]
 Detail setting menu
±0
90deg
±0
1 Detail ON/OFF selection [Detail: On, Off]
2 Total detail level selection
3 Vertical detail level selection
4 Noise suppression [Noise Suppress: 0 to 7]
5 Return to the previous menu (menu for
53 (E)
(user mode only)
The detail setting menu is provided in the user mode only.
 Detail Set 
Detail
1--------
Total Detail Level
2--------
V Detail Level
3--------
Noise Suppress
4--------
Return
5------
Using this item, ON or OFF is selected for detail
compensation.
When "On" is selected, the amount of the detail
compensation can be adjusted using the "Total Detail
Level" and "V Detail Level" menu items.
[Total Detail Level: 0 to 14, ---]
(Factory setting: 7)
Using this item, the amount of the edge enhancement in
the horizontal and vertical directions is selected.
When "Off" is selected as the detail ON/OFF selection
setting, "---" is displayed, and no selection is possible.
[V Detail Level: –7 to +7, ---]
(Factory setting: ±0)
Using this item, the amount of the edge enhancement in
the vertical direction is selected.
When "Off" is selected as the detail ON/OFF selection
setting, "---" is displayed, and no selection is possible.
(Factory setting: 0)
Using this item, the amount of screen noise generated by
the detail can be reduced. The higher the value selected,
the greater the reduction of the noise. However, if too high
a value is selected, the sharpness of detailed subjects
will be reduced.
selecting the shooting mode) [Return]
On
2
4
0