Prepare For Installation; Mount The Camera - JVC VN-T16U Quick Manual

■ Energy Conservation

When the camera is not in use for a long time, turn off the
power for safety and energy conservation reasons.
■ Copyright Protection

With the exception of the user being the copyright holder
or when permission such as for duplication has been
granted by the copyright holder, permission is required in
principle for the duplication, modification, or transmission
of copyrighted material.

Unauthorized duplication, modification, or transmission of
copyrighted material may constitute a copyright
infringement, and the user may be liable to compensate
for any damages. When using copyrighted material, be
sure to check the license agreement of the copyrighted
material thoroughly.

Prepare for Installation

Select the lens to use with your camera. This camera supports the use of a manual iris or DC iris
lens. When using a DC iris lens, it should be connected to the camera via the 4-pin square socket
located at the side of the camera.

Mount the Camera

1. Attach the camera to a pending mount.
2. Mount the camera onto the ceiling/wall and fasten it securely.
3. Connect the Safety Wire (Fall Prevention Wire, not supplied) to the camera and the wall/ceiling.
Insert the screws on the camera stand into either of the screw holes on the base. Then tighten
them up.
To prevent the camera from falling off, ensure that it is connected to a firm place
(ceiling slab or channel) using a Safety Wire (Fall Prevention Wire is not
supplied).
Pay also careful attention to the length, strength, wiring, and material (insulating
Warning
properties) of a Safety Wire (fall prevention wire) to be used. The length should
be as short as possible within the permissible range of the mounting length. The
wire should be strong enough to withstand the total weight of this product and the
fixer. (Pay also attention to the finishing at the end of the wire.) The thickness of
the wire's end of camera side should be less than 1 mm.
Must be isolated camera and the wall/ceiling which are connected by a Safety
Caution
Wire (Fall Prevention Wire).

When rights or rights holders are involved with regard to
the targeted duplicating subject, permission may be
required for shooting or using (processing) it. Be sure to
check the licensing conditions thoroughly.
■ Disclaimer

We will not be responsible for any inconveniences or
disturbances caused in the event of privacy invasion as a
result of camera footages of this product.
■ Others

Because the camera controls auto exposure by shutter
speed, flicker can be shown by fluorescent light. To
reduce the flicker, please select PAL mode if the power is
50Hz, or NTSC mode if the power is 60Hz. (Refer to
INSTRUCTIONS "4 Overview of Navigation and Controls"
- "Video Type")
3