List Of Viewer Messages; Messages Displayed In The Information Display - Canon VB-R11VE Operation Manual

List of Viewer Messages

Messages Displayed in the Information Display

Messages displayed in the information display of the Viewer are classified into the following three types.
Icon Category
Information Message
Warning Message
Error Message

Warning Message
Message
Could not connect to the camera.
The camera is busy.
Failed to get camera control privileges.
Failed to establish audio connection.
You are not connected to the camera.
Please get camera control privileges.
Another user is already connected as an
administrator.
The viewer is already connected in another
window.
No audio device.
Failed to initialize Canon Network Camera Audio
Receiver.
Insufficient memory card capacity.
Recording to memory card is not allowed.
You cannot control the camera unless you exit
Viewer PTZ.
Help messages on various buttons, pull-down lists, etc., as well as frame rate and other
information from the camera are shown.
A message will be displayed notifying the user when camera control privileges cannot be
obtained, the audio session stops, etc.
Displayed when a system error occurs in the viewer.
Connection failed due to an invalid IP address, etc.
The connection limit was exceeded.
The request for camera control privileges was denied because the camera
was being used by the Admin Viewer, etc.
Connection for audio reception failed.
An attempt was made to operate the camera when the camera was not
connected.
An attempt was made to operate the camera without camera control
privileges.
The Admin Viewer is already connected to the camera.
The viewer is already available in another window.
The [Audio] button has been clicked when there is no audio device
or the audio device has been disabled in the computer.
ActiveX plugin is not installed within ten seconds after clicking the [Audio]
button.
An attempt was made to recording to a memory card with insufficient
capacity.
Recording to the memory card failed because [Memory Card Operation
Status] > [Operation Settings] was not set to [Save Logs and Videos].
The video was clicked with the Viewer PTZ in the ON state while you have
control privileges.
Explanation
Explanation
7
269