Canon VB-S30D Operating Manual page 168

Turn off the camera.
2
There is no on/off switch on the camera. Turn the
camera on and off by plugging in or unplugging the
LAN cable (PoE power supply).
3 Turn on the power while pushing the reset switch, and
keep pushing the reset switch for 5 seconds or more.
The reset switch is located in a recessed area. Push
the switch using the tip of a slender object such as a
clip.
All settings of the camera, except for the date and
time, are restored to factory default settings.
Important
If the reset switch is pushed, network-related settings will also
be restored to factory default settings including the camera's IP
address, subnet mask, default gateway address, etc.
Accordingly, you can no longer operate the camera from the
computer you were using to connect to the camera before.
When initializing the camera, use the "Camera Management
Tool" installed in your computer to set an IP address
appropriate for the environment in which the camera is used
(See "Making Initial Camera Settings" (p. 28)).
Reset Switch
168
For VB-S30D/VB-S31D/VB-S800D/VB-S805D, attach
4
the top cover.
For top cover attachment, see the "Installation Guide"
included with the camera.
Reset Switch