Bosch GOP 250 CE Original Instructions Manual page 8

OBJ_BUCH-1322-004.book Page 8 Tuesday, February 14, 2012 10:35 AM
8 | English
Technical Data
Multi-Cutter
Article number
Preselection of orbital stroke rate
Rated power input
Output power
No-load speed n
0
Oscillation angle, left/right
Weight according to EPTA-Procedure 01/2003
Protection class
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.
Assembly
Changing the Tool
Before any work on the machine itself, pull the mains
plug.
Wear protective gloves when changing application
tools/accessories. Contact with the application tool/ac-
cessoriy can lead to injuries.
Selecting the Application Tool/Accessory
Accessory
HCS wood seg-
ment saw blade*
BIM segment saw
blade*
HCS plunge cut
saw blades,
wood*
BIM plunge cut
saw blades,
metal*
BIM plunge cut
saw blade, wood
and metal*
HM-Riff segment
saw blade*
HM-Riff delta
plate*
Scraper, rigid*
* Optional accessory; for the complete accessories please see Bosch
accessory programme.
2 609 932 826 | (14.2.12)
min
* Optional accessory; for the complete accessories please see Bosch
Material
accessory programme.
Wooden materials,
plastic
Mounting/Replacing the Application Tool/Accessory
Wooden materials,
(GOP 250 CE)
plastic, non-ferrous
If required, remove an already mounted application tool/
metals
accessory.
Wooden materials,
For removing the application tool/accessory, loosen the
plastic, gypsum and
screw 7 with the Allen key 8 and remove the application tool/
other soft materials
accessory.
Metal (e. g. unhard-
Mount the requested application tool/accessory (e.g. plunge
ened nails, screws,
cut saw blade 6) in such a manner on the tool holder 4 that the
smaller profiles),
offset faces downward (see illustration on the graphics page;
non-ferrous metals
marking on the application tool/accessory is readable from
above).
Wood, metal, non-
ferrous metals
Turn the application tool/accessory to a position favourable
for the respective job, and allow it to engage into the cams of
the tool holder 4. 12 different positions are possible, each
Grouting joints, soft
offset by 30°.
wall tiles, glass-fibre
reinforces plastic
For more intermediate positions, the adapter 9 (accessory)
and other abrasive
can be used: Allow the adapter to engage with the smooth
materials
side onto the cams of the tool holder 4 (see illustration on the
graphics page). Position the application tool/accessory onto
the adapter in any position.
Fasten the application tool/accessory with bolt 7. Tighten the
Carpets, coverings bolt with Allen key 8 until the spring washer of the bolt faces
flush against the application tool/accessory.
Check the tight seating of the application tool/acces-
sory. Incorrect or not securely fastened application
tools/accessories can come loose during operation and
pose a hazard.
GOP 250 CE
3 601 B30 0..
W 250
W 150
-1
8000–20000
° 1.4
kg 1.5
/II
Accessory Material
Scraper, flexible* Silicone and other
elastic materials
Base plate for Depends on sanding
sanding, series sheet
Delta 93 mm*
GOP 300 SCE
3 601 B30 5..
300
180
8000–20000
1.4
1.6
/II
Bosch Power Tools