Makita LS1013 Instruction Manual page 19

When cutting crown and cove moldings, set the bevel angle and miter angle as indicated
in the table ( A ) and position the moldings on the top surface
of
the saw base
as
indicated
in the table
(6).
Bevel angle
In the case of left bevel cut
Miter angle
Table (A)
I
0
0
0
@
For inside corner
-
For outside corner
-
Right 31
6" Right 35 3'
Left 33 9' Left 30° Left 31 6 " Left 35 3'
Right 31 6 " Right 35 3'
Molding position
in Fig (C)
Molding edge against guide fence Finished piece
Ceiling contact edge should be
against guide fence
Finished piece will be on the
Left side of blade
For inside corner
will be on the
Ceiling contact edge should be
I
H'gnr
'Iae
Or
'lade
I
@
I
against guide fence
(Example)
In the case of cutting
52/38'
type crown molding for position
0
in Fig (C)
*Tilt and secure bevel angle setting to
33 9'
LEFT
*Adjust and secure miter angle setting t o
31 6 "
RIGHT
*Lay crown molding with its broad back surface down on the turn base with its CEILING
CONTACT
EDGE
against the guide fence on the saw
*The finished piece to be used will always be on the LEFT side of the blade after the
cut has been made
19