Makita LS1013 Instruction Manual page 25

Carrying tool
Make
sure that
the tool is
unplugged Secure the blade at
0"
bevel angle and the turn
base
a t 52" miter angle to the right Secure the slide poles after pulling the carriage toward you
fully Lower the handle fully and lock
it
in the lowered position by pushing in the stopper
pin Carry the tool by holding both side of the tool base as shown in the figure below
If
you remove the holders, dust bag, vise, etc
,
you can carry the tool more easily
CAUTION:
*Always secure all moving portions before carrying the tool.
*Stopper pin is for carrying purposes only and not for any cutting operations.
.MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and unplugged before attempting to perform
inspection or maintenance.
WARN I NG :
Always be sure that the blade is sharp and clean for the best and safest performance.
Adjusting the cutting angle
This tool is carefully adjusted and aligned at the factory, but rough handling may have
affected the alignment. If your tool is not aligned properly, perform the following:
1) Miter angle
Push the carriage toward the guide
fence and tighten the knob to secure
the carriage. Loosen the grip which
secures the turn base. Turn the turn
base so that the pointer indicates 0" on
the miter scale. Then turn the turn base
slightly clockwise and counterclockwise
to seat the turn base cozily in the 0"
miter notch. (Leave as it is if the pointer
does not indicate
O".)
Loosen the four
hex bolts securing the guide fence using
the socket wrench.
25