How To Mount And Attach Options To The Lcd Monitor - Mitsubishi Electric LDT32IV (BH548) User Manual

How to Mount and Attach Options to the LCD Monitor

You can attach mounting accessories to the LCD monitor in
one of the following two ways:
1. In the upright position
2. Lay the screen face down
Table
Lay the protective sheet on a table, which was wrapped around
the monitor when it was packaged, beneath the screen surface
so as not to scratch the screen face.
This device cannot be used or installed without the Tabletop Stand
or other mounting accessory. Failure to follow correct mounting
procedures could result in damage to the equipment or injury to
the user or installer. Product warranty does not cover damage
caused by improper installation.
Failure to follow these recommendations could result in voiding
your warranty.
When using with other mounting accessory, it must be a VESA-
compatible mounting method and the screws must be M6 of size
and 10mm or longer of length under consideration of the thick-
ness of the mounting method. (Recommended torque: 470 -
635N•cm). MITSUBISHI ELECTRIC recommends using mount-
ing interface that comply with TÜV-GS and/or UL1678 standard
in North America.
3. Ventilation Requirements for enclosure
mounting
To allow heat to disperse, leave space between surround-
ing objects as shown in the diagram below.
4. To avoid falling down
Protective Sheet
Fasten the LCD monitor to wall using a cord or chain,
which is sufficient to support the weight of the LCD monitor
(LDT321V: approx. 17.5kg / LDT371V: approx. 22kg).
Tabletop Stand
LDT321V: 360mm
LDT371V: 462mm
Before moving the LCD monitor, the cord or chain should
be removed.
English-12
See diagram below.
Screw Holes
Cord or Chain
Clamper
Screw