Vcr To A Cable Box (Audio & Video) - Mitsubishi Electric LT-40133 Owner's Manual

24
3. TV Connections
VCR to a Cable Box (Audio & Video)
Required: Two coaxial cables, right and left audio
cables, S-Video or composite video cable, plus cables
required to connect the TV to the cable box.
Connect the incoming coaxial cable to CABLE IN
1.
on the cable box.
2. Connect one coaxial cable from OUT on the cable
box to ANTENNA IN on the VCR back panel.
3. Connect the cable box outputs to the TV as shown
in one of the options listed below. This connection
allows the TV to receive the best available signal
directly from the cable box. See the referenced
figures in this chapter, "TV Connections."
Option 1 (see Figure 1, pg. 19): Component video
output to the TV's COMPONENT INPUTS Y Pb Pr
jacks; analog stereo audio to the associated AUDIO
jacks.
OR
Option 2 (see Figure 2, pg. 20): HDMI output to
the TV's HDMI jack.
OR
Option 3 (see Figure 3, pg. 20): S-Video output to
the TV's INPUT S-VIDEO jack; analog stereo audio
to the associated AUDIO jacks.
Figure 10. Connecting a VCR to a cable box
4. To use the TV speakers with the VCR, connect left
(white) and right (red) audio cables from AUDIO OUT
on the VCR to INPUT AUDIO L (MONO) and AUDIO R
on the TV back panel #1. If your VCR is mono (non-
stereo), connect only the white (left) cable.
5. Connect either an S-Video or composite video
cable from VIDEO OUT on the VCR back panel to
INPUT VIDEO or INPUT S-VIDEO on the TV back
pane #1. Connect only one type of video cable.
S-Video is recommended, if available.
Note: When using this connection configuration with
the connections used in step 3, it is possible to
view live cable programs through the VCR De-
vice. For best picture quality, however, always
view live cable programs directly from the cable
box device.