Mitsubishi Electric MJ-E152AF-H Instruction Manual page 22

Draining
When the tank is full (approximately 5 L), the unit automatically stops and the FULL lamp lights.
Please empty the tank.
1
Slide the tank out
steadily with both hands.
2
Tank Lid
Tank
Guard
Floating Element
Do not remove or
dismantle the floating
element.
(There will be continuous sounds "bleep bleep bleep".)
(Louvre stops.)
Hold the water tank.
Pour the
water out
from here.
After pouring out the water, replace the water tank,
and the FULL lamp will go out. The unit restarts.
When the FULL lamp is on, other operations
are forbidden except for pressing the POWER
switch.
In OFF TIMER operation, the FULL lamp is ON
as indicator.
When the water tank becomes full, the unit
stops dehumidification but the air supply
continues.
Though the FULL lamp lights, there will be no
warning sound. The air supply continues even
if the water tank has been removed.
3
4
Confirm that the tank lid and the tank guard are
securely attached, and push the tank in with both
hands.
(Sounds "Blip".)
If the tank lid and the tank guard are not
properly replaced, you may have problems
removing the water tank.
If the water tank is not installed correctly,
the FULL lamp will light and the unit will not
operate.
Secure the lid and guard properly or else the tank
may become stuck.
If the tank is not installed correctly, the FULL lamp will
come on, and the unit will not operate.
Do not remove or dismantle the floating element from the
tank. If it is removed, the unit cannot detect the water
level, and this could result in leakage.